If the chosen method did not help to clean the tile from complex impurities the first time, repeat the procedure or try another remedy.
It will help to get rid of simple impurities like soap stains and fresh plaque from water. To clean rust, mold and other stubborn stains, use another option.
Moisten the sponge in warm water and rub it thoroughly on a bar of household soap. Apply the foam to the tile and leave for 30 minutes.
After that, walk the sponge over the coating, paying special attention to the problem areas. Wash off the remaining soap with a clean, damp cloth, and then wipe the tile dry.
The product, which is available in almost every kitchen, copes with limescale and mold.
Mix vinegar with 1 liter of water. Pour the solution into a container with a spray gun and spray on the tile. If the seams are sealed with cement grout, try to apply the product to the dirt point-by-point with a cotton pad or a piece of cloth so as not to spoil the material.
Let the vinegar work for 20-30 minutes, and then remove the dirt with a sponge. Wash off the remaining product with a clean, damp cloth.
Homemade detergent effectively removes most impurities, including fresh traces of rust.
In a deep bowl, quickly mix the baking soda, hydrogen peroxide and liquid soap. As a result of the chemical reaction, the components will begin to hiss and release a lot of oxygen foam. Apply the product on the tile and leave for 20 minutes.
Then carefully walk over the coating with a sponge, removing dirt. Wash off the remnants of the mixture with a damp cloth, and then wipe the tile dry so that there are no streaks left.
The pharmacy product not only copes with dirt, but also gives a glossy tile shine.
Dissolve 50 ml of ammonia in 1 liter of water. Pour the liquid into a spray bottle and spray on the tile. Leave the mixture on for 10-15 minutes, then wipe the surface with a dry cloth.
To combat mold, you can prepare a more concentrated solution by mixing ammonia with water in a ratio of 1 : 1. Apply the composition to dark spots with a cotton pad and leave for 1-2 hours. Remove any remaining dirt with a dry cloth.
This method allows you to get rid of soap stains and old lime plaque, and also returns to the tile shine.
Dissolve citric acid in 250 ml of warm water. Pour the resulting liquid into a spray bottle and spray on the tile.
After 20 minutes, clean the surface with a sponge or microfiber cloth, and then rinse off the remaining product with a damp material.
Chlorine in the composition of liquid "Whiteness" is able to defeat even black mold.
Apply the product to the tile with a cloth or sponge and leave for 15-20 minutes. At this time, leave the bathroom and close the door.
After that, wash the tile thoroughly with a cloth and water to get rid of chlorine residues. Do not forget to ventilate the room.
